The Odenthal EZ-Set 4-Cycle mount is the gold standard for mounting LO206 and Tillotson 4-Cycle motors. Multiple threaded M8 holes on the top plate allow for a lot of adjustment when mounting the motor using the included studs. The EZ-Set system makes adjusting the chain and motor position a breeze! Now available in 8 degree and 0 degree top plates!
Each motor mount comes with the following hardware needed to mount your engine:
- Odenthal EZ-Set Top Plate, Base Plate, and (2) Clamps
- (4) M10 Threaded bolts
- (2) M10 washers (for EZ-Set slider mechanism)
- (4) M6 Threaded Motor Mount Studs (w/4mm Allen Head)
- (4) M6 Metal Lock Nuts (to clamp down on motor once mounted on engine mount)
- Odenthal Sticker
2 motor mount clamps are required and are sold separately. To determine the size, using a caliper, measure the frame rail diameter. Then measure the total distance outside to outside of the two rails that the engine mounts to and subtract the rail diameter from this number. For example, if your frame rail diameter is 30mm and the total width of your frame rails is 120mm, subtract 30mm from 120mm and your center to center diameter is 90mm. Therefore you need two K30 clamps (30x90mm)
