The Odenthal EZ-Set 2-Cycle Motor Mount uses a two-piece sliding design, so you can adjust chain tension in seconds without loosening the clamps or moving the whole engine. It comes with the top and base plates and mounting hardware. Clamps are sold as options by size.
This is the latest version with less weight and better cooling with the new cooling channels on the top plate. The mount is available in 0 Degree, 5 Degree and 10 Degree versions. The 10 degree is the old style plate with no cooling cutouts.
Each motor mount comes with the following hardware:
- Odenthal EZ-Set Top Plate and Base Plate
- (2) M10 Threaded bolts
- (2) M10 washers (for EZ-Set slider mechanism)
- (4) M6 Threaded Motor Bolts
- Odenthal Sticker
Motor Mount Clamp Sizes:
-K25: Fits 25mm Frame/90mm Center Spacing
-I25: Fits 25mm Frame/92mm Center Spacing
-I28: Fits 28mm Frame/92mm Center Spacing
-I30/K28: Fits 28mm Frame/90mm Center Spacing & 30mm Frame/92mm Center Spacing)
-I32/K30: Fits 30mm Frame/90mm Center Spacing & 32mm Frame/92mm Center Spacing)
-K32: Fits 32mm Frame/90mm Center Spacing
*NOTE: Motor mount clamps are required for installation, ensure you select the correct size for your chassis.
